Ace Pumps (FMC-HYD-203) Discharge Pump
1 1/4" Suction x 1" Discharge Pump; 100 PSI, 4600 RPM, 75 GPM, 3 GPM Hydraulic Motor; Open Center System; FMC-HYD-203
The 203 motor required 2 GPM (7.6 LPM) and 3 GPM (11.4 LPM)hydraulic fluid input. Recommended for engineered systems with limited oil flow.
Ace developed the first hydraulic motor driven pump at the request of John Deere in 1969. Many of the original pumps are still operating today after more than 30 years of service.
Centrifugal pump design provides good resistance to abrasive solutions and extra flow for agitation. The advantages of the hydraulic motor driven pump are mounting versatility, customized performance, and ease of maintenance. All hydraulic driven pumps are equipped with a stainless steel shaft and wear ring for excellent corrosion resistance.
MOUNTING VERSATILITY: The location of the pump is not tied to the PTO or engine drive shaft; the pump can be mounted in a variety of locations to suit application requirements.
CUSTOMIZED PERFORMANCE: The performance is dependent on the supply of hydraulic oil to the motor and not necessarily tied to engine speed. A hydraulic Roundup logo driven pump can produce higher pressures than PTO or belt driven pumps. They can also hold constant pressure at varying engine speeds on closed center hydraulic systems.
EASY MAINTENANCE: On a hydraulic driven pump there are no belts to align or break. Separate pump and hydraulic motor shafts simplify repair and replacement. Two main pump bearings support shaft loads. All pumps are equipped with easily replaceable Viton mechanical seals.
Ace Pumps Part #
49826 = 1¼" Suction x 1"; FMC-HYD-203